Product reference
YD30 Accelerometer / YD30W Acceleration and Temperature Sensor
Separate catalog specifications for YD30 and YD30W, including known YD30 differences across manuals.
On this page
YD30 specifications differ across sources. Confirm the applicable hardware configuration; for YD30W, confirm the ordered configuration and explosion-protection documentation.
YD30 acceleration sensor
| Parameter | Specification |
|---|---|
| Sensitivity | 100 mV/g; other values customizable |
| Frequency response | 0–10 kHz (±3 dB) |
| Amplitude nonlinearity | ≤ ±1% |
| Transverse sensitivity ratio | ≤ 5% |
| Excitation voltage | +18 to +28 VDC, constant-current supply |
| Excitation current | 2–10 mA |
| Maximum shock | 2000 g |
| Operating temperature | −40 to +85°C |
| Protection | IP68 |
| Housing | 304 stainless steel |
| Output connection | Two-pin circular connector with 3 m cable |
| Default mounting thread | M6×1 |
YD30W acceleration and temperature sensor
| Parameter | Specification |
|---|---|
| Explosion-protection marking | Ex ia IIC T6 Ga |
| Temperature range | 0–100°C |
| Sensitivity | 100 mV/g; other values customizable |
| Frequency response | 0–10 kHz (±3 dB) |
| Amplitude nonlinearity | ≤ ±1% |
| Transverse sensitivity ratio | ≤ 5% |
| Excitation voltage | +18 to +28 VDC, constant-current supply |
| Excitation current | 2–10 mA |
| Maximum shock | 2000 g |
| Operating temperature | −40 to +85°C |
| Protection | IP68 |
| Housing | 304 stainless steel |
| Output connection | Four-pin circular connector with 3 m cable |
| Default mounting thread | M6×1 |
YD30 differences across documented sources
| Parameter | Product catalog edition | YD30 product manual | CZ900 system manual |
|---|---|---|---|
| Frequency response | 0–10 kHz (±3 dB) | 0–2 kHz (−3 dB) | 0–10 kHz (−3 dB) |
| Protection | IP68 | IP64 | IP64 |
| Maximum shock | 2000 g | 10000 g | 10000 g |
These are known differences, not a statement that every other parameter agrees. The hardware versions and currently applicable values have not been confirmed. Keep each source's specifications separate and confirm the required configuration; do not combine them into a single specification set. This difference table concerns YD30 only and does not apply to YD30W.